Wednesday, 16 November 2011

BIlges painted.

A coat of gloss in the bilge and 6" up the cabin side will help keep the bilge easy to clean and resist corrosion although it is unlikely ever to be seen after the floor goes down.
Prior to painting the plate was brushed and vacuum cleaned paying close attention the the scuppers.
(ie the drain holes at either end of the knees)

Looking back over the fuel tank toward the stern.

The back cabin range will be installed at the port stern end of the counter plate so, because of the heat, this are will not be spray foamed. It has therefore been painted.

No comments:

Post a Comment